Where is the three-wire split vacuum connector used? Why is it designed like this?

    The three-wire vacuum connector is a vacuum connector specially developed by Huipu Technology after analyzing the domestic and foreign markets. At present, only Huipu Technology provides this type of product in the entire network and has applied for a patent. It is mainly used in three-wire sensor wiring and wiring in a vacuum environment.

    Sensor outlets generally have three connection methods: two-wire system, three-wire system and four-wire system. Due to the wide variety of sensors, such as photoelectric sensors, proximity switches, travel switches, optical fiber sensors, laser sensors, etc., it outputs ON/OFF switch models or standard current (4~20mA or 0~20mA), standard voltage signals ( 0~5V or 0~10V) or other special signals. Because this kind of signal has low current and low voltage, and is mostly connected by three-wire system, it is easy to realize the universal plug.

    There is another obvious feature of the sensor layout and wiring, that is, the installation points are relatively scattered, and the sensor comes with different types of cables. The sensor must be installed in the correct relative position to the measured object in order to exert its maximum detection efficiency. If multiple sensor cables are connected to a multi-core connector, the length of the overall wiring harness will vary, and the cables will cross, which will cause inconvenience to assembly, disassembly, and maintenance.

    The three-wire split vacuum connector developed by Huipu Technology can significantly improve this problem. Using split plugs, each sensor uses a separate 3P plug, which can effectively avoid the problem of inconsistent cable length and wire types. If the sensor needs to be replaced or re-wired, you only need to pull out the corresponding plug separately, without affecting the wiring of other sensors.

    Both the vacuum side and the atmosphere side of the three-wire split vacuum connector are pluggable. The user can prepare all the cables on both sides in advance, and finally plug them into the vacuum connector.

    In addition, Huipu Technology has adopted the anti-sparking design of the power vacuum connector in the design of the split plug. Therefore, the three-wire split vacuum connector can also be used for small current DC or AC power supply.

    Different from the common vacuum connectors on the market, Huipu Technology’s products generally start from the actual needs of the user’s assembly and wiring, and strive to achieve a balance between high pin density, smooth insertion and removal, large load current, and convenient installation and removal. Every slot point that may cause users to complain, continue to improve, and provide the most cost-effective solutions and products.

(Huiputech)